![Samples available upon request! Samples available upon request!](https://cdn11.bigcommerce.com/s-cejdq9en/images/stencil/300x300/products/287/1392/x1333__66066.1603659664.jpg?c=2)
"D" Rubber Seal X105-HT - Sold by the CONTINUOUS YARD!
TRIM-LOK
$5.95
Sold by the CONTINUOUS YARD!D-shaped Style EPDM Sponge Rubber Seal, with a height of .437" and a width of .375"Tape: HT - General Acrylic PSA / This acrylic based adhesive is best used to hold the rubber seal in place while installed in a static application or compressed between two stationary objectsMay be used in some light duty dynamic applications against a variety of substrates. Good heat performance -20F to +158F. Please Note: During application ambient temperature must be above 60° F.Recommended temperature range for general applications: -20°F. through +150°F, Sponge Rubber (EPDM)Application: For optimum performance - 25% - 50% maximum compression recommended
Resistance Ratings: Excellent resistance to water absorption, ozone, sunlight aging, low temperature, and compression setFlammability and Code Compliance: FMVSS 302, UL 50CLEANING AND APPLICATION INSTRUCTIONS
Regardless of bonding surface, it must be clean and free of surface contaminant such as oil, grease, mold release and dirtMost bonding failures are due to improperly cleaned surfaces. Prior to applying any adhesive, Clean surface with 50/50 denatured alcohol and water solution
Resistance Ratings: Excellent resistance to water absorption, ozone, sunlight aging, low temperature, and compression setFlammability and Code Compliance: FMVSS 302, UL 50CLEANING AND APPLICATION INSTRUCTIONS
Regardless of bonding surface, it must be clean and free of surface contaminant such as oil, grease, mold release and dirtMost bonding failures are due to improperly cleaned surfaces. Prior to applying any adhesive, Clean surface with 50/50 denatured alcohol and water solution